This is the Team Associated 1/10th scale RC10L3 Oval Graphite Chassis Car Kit.

FEATURES: This is based from the RC10L2 kit
          All new 3 shock rear suspension using 2 VCS (Volume Compensating
            Sysyem) Micro shocks to handle side-to-side dampening
            and eliminating tweak screws and larger center Macro shock
          1/2" wider battery placement slots on the left side of chassis
            compared to the previous RC10L2
          Featherweight, energy absorbing front black foam bumper
          Blue titanium turnbuckles
          Mounted and trued Jaco tires on 6-spoke black wheels
          Fully adjustable front suspension with adjustable caster,
            camber, toe-in, in-line steering blocks and threaded axles
          Redesigned milled aluminum rear hubs with clamping left side
          Graphite through construction very concentric & light rear axle
          Centered rear pod with optional offset using #8459 hub
          Aluminum front end brace
          Adjustable wheelbase (1/4" by moving front suspension)
          Graphite T-bar pivot brace
          Symmetrical (0.075") fiberglass T-bar design
          Composite left rear and right aluminum bulkhead motor mount
          Molded rear right nerf wing bars
          Adjustable ball differential (not pro-type)
          2-part wide black plastic and foam front bumper
          Standard size diff rings (not pinned and not Small type)
          In-line steering blocks (off-set optional)
          Dynamic strut type front suspension
          Graphite 90 degree weave chassis with countersunk holes
          9-battery slots (6 on left and 3 on right)
          Rear alxe ride height adjusters
          Graphite upper and lower pod plates
          Full ball bearings                                                .

SPECS:    Length: @20"
          Width:  @8.4"
          Wheelbase:  @10.2"

INCLUDES: All components for rolling chassis (front and rear suspension,
            foam medium tires mounted on wheels, 81 tooth 48 pitch spur gear,
            ball bearings, servo saver, aluminum wheel hubs, graphite axle,
            graphite chassis, servo saver, antenna tube, 30 weight silicone-
            shock oil, double-sided tape, hex wrenches, silicone grease, decals
            ,double-sided tape, hex wrenches, silicone grease, instructions and
            parts list.

REQUIRES: All electrics such as 2-channel radio, servo, motor, electronic speed
            control, 48 pitch pinion gear, batteries (saddle type), strapping
            tape, charger, paint, narrow (190,not standard) body, threadlock,
            tools and drilling chassis.

COMMENTS: Bearing Sizes: 4-  1/4x3/8" flanged for rear axle
                         4-  3/16x5/16" flanged for front wheels
          Also available: RC10L2 On-road wide ASCC0515
          Optional parts for 5th body post for hood support-
            ASCC3465 #6332 hood pin (body clip), ASCC5304 #8304 body
            post and ASCC8103 #6280 8/32x1/2 aluminum flat-head screw.
          Optional off-set steering blocks need 1 ASCC5421 #8421 off-set
            steering blocks, 1 ASCC1587 #3213 off-set axles and
            (4) 1/8x5/16 flanged bearings (2 DTXC1403).
                                                                     AXY 8/5/98
                                                                          ir/jl