This is the Astroflight 803V direct drive brushless motor and controller.
FEATURES: Super high efficiency 5-turn brushless motor
Powerful samarium cobalt magnets
Ball bearing supported shaft
Standard 1/8" motor shaft with 3/16" prop adapter
Brushless electronic speed control included, with BEC.
Smaller and lighter than ferrite motors of similar power
Designed for sport applications
INCLUDES: One 020 motor with speed control, Futaba J connecter, and zero-loss
battery connector.
One spec sheet and warranty card
SPECS: Winding: 5 turns
Speed Control: 12 MOSFETs
Typical Nicad: 7 to 8 cells
Max Amps: 16 to 18 amps
Input power: 125 to 165 watts
Motor Kv: 3000 RPM/volt
Winding resistance: 0.135 ohms
No load amps: 1 amp
Motor shaft: 1/8" diameter
Prop shaft: 3/16" diameter
Motor diameter: 0.95"
Motor length: 1.75"
Speed control: 0.9" x 1.2"
Motor weight: 2.3 oz.
Speed control weight: 0.8 oz.
Typical prop: 6x3.5 or 5.5x4
REQUIRES: 7 cell, 500 mAh battery and Zero-Loss connector
COMMENTS: Brushless motors can not handle as much current as brushed motors,
due to the complexity of the speed controller. However, low current
draw means these motors can use a lower capacity battery and
therefore a lighter power system over all.
To use this motor with an Airtronics radio, use AIRM4399 (plug kit),
(adaptor wire, requires trimming the polarity tab on
the J connector.)
There is no set battery/prop/motor combination. The included spec
sheet has several suggested combinations, but the modeler needs to
choose his own battery and prop.
BBS 9/9/99
ir/jl
updated4-09-02kh