This is a Radio Controlled, Electric Powered, Balsa and Plywood
Great Planes Ryan STA Sport Scale Aerobatic, Airplane Kit.
For Intermediate to Advanced Modeler/Flyers.
Recommended for modelers who have had trainer airplane experience and
also have safely flown/landed low wing planes.
FEATURES: Easy interlocking balsa and plywood construction, with built-in
thrust angles and a wing that assembles flat on die-cut tabs.
By removing one pin, the cockpit lifts out to reveal a spacious
radio compartment, with plenty of room for all on-board gear.
Installation of motor and gear drive takes only minutes, thanks to
a large mounting area.
White ABS plastic cowling, wheel pants, and head rest. The cowl
completely encloses it all to preserve the Ryan's realistic looks.
Scoops and vents in the cowl convert passing air into cooling
power.
Crystal-clear butyrate canopy.
Fixed, pre-formed wire main landing gear.
Dual aileron servos for precision and authority.
Steerable tail wheel adds maneuverability to the stability provided
by the wide-stance main gear. An ideal ground-handling combination
for the first-time taildragger pilot.
Hardware included: Wire landing gear, pushrods, screws, control horns
and tail gear wire.
Warranty: 90 Day warranty on materials.
INCLUDES: All wood to construct the airplane, cockpit with clear canopy,
ABS plastic cowling and wheel pants, decals, photo-
illustrated instructions, and full-size rolled plans.
REQUIRES: 600 Size Electric Motor 14 Turn Reverse Motor
C-30 or C-50 Speed Control or Equivalent
7-Cell 1700-3000 mAh Battery
Gear Drive
Charger
9x8 Prop
3:1 ratio/ 15 Tooth Pinion
Radio: 4-5 Channel
Servos: 4 Mini Servos - 44 oz/in torque minimum
Covering: 2 - 6" rolls Topflite Monokote
Y-Harness: 1 required
Misc. Items:
1/4" foam rubber padding, propeller, building and field equipment
SPECS: Wingspan: 49" (1245mm)
Wing Area: 401 sq in (25.9dm2)
Weight: 3-3.5 lb (1360-1590kg)
Wing Loading: 17-20oz/sq ft (51-61 g/dm2)
Length: 36.3" (920mm)
Airfoil: Semi-Symmetrical NAC2412 Low Wing
Center of Gravity: 2-5/8" (66.7mm) Back from the wing's leading edge
at the fuselage sides.
Control Throws- High Rate Low Rate
Elevator: Up & Down 3/8" (9.5mm) 1/4" (6.4mm)
Rudder: Right & Left 1" (25.4mm) 3/4" (19mm)
Ailerons: Up & Down 1/2" (12.7mm) 3/8" (9.5mm)
Incidence: -2 degrees down thrust.
COMMENTS: The pilot shown inside the plane is not included.
Decal sheet RYN1D01 sold only through GP Manufacturing includes:
Two 1-1/4" x 3/4" red, white & blue American flags
Two 1-3/8" x 3/8" black N61MH
Two 2-5/8" x 5/8" red, black & white Great Planes logos
One 2-1/4" x 1-5/8" ownership tag
kh11/26/01
ir/kh
|