This is the Onboard Electric Starter for the Fuji BT-50SA Engine.
This mounts onto the engine and drives the rearmost section of the
crankshaft via a one-way bearing.
Also works on the BT-50SB FJIG0047
FEATURES: Eliminates the need for a field starter system, and offers more
realistic ignition through a toggle switch on the radio.
A Soft Start relay switch allows the starter to spin up to speed
gradually, for more reliability and less wear on the one-way
bearing.
Easy to install- the relay is pre-wired with all connections
required for most systems.
Operates on a 12V power source, low resistance NiCd batteris
recommended,
INCLUDES: One Onboard Electric Starter On/Off Switch Unit with the following
pre-wired to the unit:
- 130mm lead w/JR-Hitec connector (plugs into RX)
- 100mm lead w/male battery connector (DTXC2280)
Red is possitive (+) Black is negative (-)
The red lead also has an in-line fuse holder w/30 amp fuse
- 130mm lead with on/off switch
- 125mm leads w/no connector (these go to the starter motor)
White is possitive(+) Blue is negative (-)
One Starter Motor Unit including w/one-way bearing.
This unit is pre-mounted to the plate that screws onto the back
of the engine.
One red & one black 14 awg wire lead 500mm long (this is to connect
the battery to the switch unit. You will need to solder the
included battery connectors to the ends of these leads. One end
will plug into the switch unit and the other plugs into your
battery)
Two capacitors
Two female battery connectors & One Male batter connector (DTXC2250)
Misc. Harware includes the following:
- Four round aluminum spacers 11.5 x 6.5 x 29.5mm (OD x ID x L)
- Four round aluminum spacers 7.5 x 5.3 x 10mm (OD x ID x L)
- Four steel washers 15.5 x 5.5x 1.5mm (OD x ID x thickness)
- Four steel cap head screws 4x55mm
- Four steel flat head counter sink screws 4x20mm
- Four blind nuts
One black rubber electric motor end cover
No Instructions are included
REQUIRES: Some soldering of electrical connections is required.
4mm allen wrench for cap head bolts
3mm allen wrench for flat head counter sink srews
Mounting
Plate
SPECS: Height: 108mm
Width: 96mm
Thickness: 5mm
Firewall/Mounting Plate Holes (center to center)
- Top to Bottom 95mm - Side to Side 83mm
Engine/Mounting Plate Holes (center to center)
- 68mm Top to Bottom - Side to Side 68mm
COMMENTS: The in-line fuse is the old automotive style (round) and can
be purchased at any automotive supply store.
The switch unit has an Input voltage rating of 7.2 to 14.4 volts DC
and an Output rating of 35 amps.
I recommend using Deans 2 Pin Connectors (WSDM3001) in place of all
the battery connectors. This will eliminate any possiblility
of the connectors experiencing thermal melt-down.
kh05-30-02
updated tjt 070502
ir/kh