This is the Magnum 3PK Pistol-Grip Radio System from Futaba.
Seven Color LED Monitor, Brake mixing for 1/5 Scale cars, Futuristic
Look, New Large Backlit Display, and Adjustable Steering Wheel position,
*NEW generation of modulation called HRS**** all make this radio unique.
FEATURES:
PROGRAMMING FUNCTIONS:
10 Model memory (10 more with optional CAMPac), model copy and reset
10 Digit Model and user naming: English or Japanese characters
PCM/PPM/HRS Selectable with 3-ch adjustable FailSafe for PCM/HRS
3 Function selection modes (New User, Race Ready Driver and Expert
provide 1/2/3 menus of features for just the right fit!)
PLUS the direct selection 2-key menu to up to 6 functions.
Steering Dual Rate and Dual Rate 2, both adjustable while driving
Servo display to show all 3 servo positions for easy setup/diagnostic
Anti-Skid Brake System (A.B.S.) (Keeps tires from skidding, or
locking-up, even on gas cars) (with 5 adjustments)
Throttle Acceleration (decreases lag time before clutch or brakes
are engaged)
Steering and throttle exponential (3 forward expo types)
end point adjustments for all 3 channels (EPA/ATV)
Steering and Throttle servo speed limiters
Brake mixing for 1/5th scale cars with sep front and rear brakes
System adjustments for back lighting, pilot lamp color, home display
Servo Reversing
Idle-up for easy starts and engine cut for boat engine shut off
Start (Preset throttle start control. Limits throttle at the
beginning of a race to give smoother acceleration and less wheel
slip.) (similar to traction control on 3PJS)
Advanced timer w/100 lap recall & trigger activation
Trim/dial function selection (can assign different functions to the
different trim controls and dials)
Switch function selections (can assign different functions to the
different switches)
Subtrim adjustments
Step trim adjustments (allows changing of trims in finer increments)
Programmable mixing
Tilt mixing for adjusting the trim tabs with the 3rd channel on boats
Third channel assignable to any dial/switch/trimmer/mix
MC-SETUP function for HRS receivers to properly setup ESCs
ADJUSTER function to manually calibrate trigger and wheel
EQUIPMENT FEATURES:
Optional DSC cord support for operating receivers without transmitting
LARGE REAR Facing LCD plus Seven Color Pilot Lamp for easy ID.
One Year Warranty
Digital trim with reset
Left Hand reversible
Steering wheel tension adjust (can be adjusted without opening radio)
Trigger stop function (mechanical ATL) and programmable ATL
Display switch (allows functions to be set without transmitting)
Audible, adjustable alarm tone and lap counting tones
Headphone jack for hearing the alarm tones at a noisy track
INCLUDES: One 3PK Transmitter No Number
One RF Transmitter Module FUTL13**
- One Transmitter Antenna
One R113IP Receiver FUTL0304 (75MHz)
FUTL0300 (27MHz)
One TX 9.6V 700mah Battery FUTM1462
One RX Battery Box w/"J"Connector FUTM1595
One Switch Harness FUTM4370
One Flag/Number Set No Number
One Instruction Manual FUTZ8533
OPTIONAL: * Campac 16K, 8 Model Memory (FUTM9405)
* DSC cord
* MC SETUP cord
REQUIRES: Servos (either digital or NON-digital)
**DIGITAL SERVOS ONLY WHEN USED W/HRS RECEIVERS**
COMMENTS: Can also use regular PPM (FM) and HRS (R203HF) receivers.
To use the DSC function you will need to use a Y-harness(HCAM2500).
kh06-17-02
upd AMC 9/17/02
upd JPG 2/26/03