This is the T-400GD Gear Drive Motor System w/Speed Control from Great Planes.
Designed for use with the Fundango Park Flyer airplane or other models that
require a speed 400 motor, 1.7:1 gear ratio gearbox & mini speed control.
FEATURES: Light weight, complete, easy to use power system for park flyers.
Aluminum gearbox with nylon gear.
INCLUDES: One T-400 Ferrite Motor (GPMG0325)
One T-400 1.7:1 ratio Gear Box (GPMG0220)
One 14 tooth pinion gear Not Carried Separately
One 3 x 3 pinion gear set screw
One APC 10x7 Slo-Flyer Propeller (APCQ5018)
Two APC Prop Hub Adapters
One 6 x 14mm washer
Two 2.6 x 5mm cap head mounting screws
Two 2.6mm phillips head motor mounting screws
One Instruction Sheet
One ElectriFly C-20 High Freq Mini Electronic Speed Control w/BEC
(GPMM2020)
REQUIRES: Park Flyer Aircraft
A .050" hex wrench to tighten the pinion set screw.
A 1.5mm hex wrench to tighten the prop adapter set screw.
Small phillips screwdriver
SPECS: See individual item descriptions for further information.
COMMENTS: This same system is also available with-out the electronic speed
control, use GPMG0415.
Instruction sheet includes a cross-sell ad for the Hobbico C5 nano
servos. This is JUST A CROSS SELL.
Fundango, the model around which this package was designed,
DOES NOT use C5 nano servos. It uses mini servos such as the CS35.
TECH NOTICE FUNDANGO/FUNDANGO POWER SYSTEM USING the 1.7:1 Gear Box:
Improving the performance and preventing damage to your system.
1) The gear mesh is Critical. Set the gear mesh by running a sheet of notebook
paper between the gears. It should and will feel sloppy. If the gear mesh
is tighter than this the motor will OVERHEAT (60 degrees hotter!) and
immediately lose performance. If you have already run your motor with
this tight gear mesh and performance is lacking, please send us the
problem motor with a copy of this tech note and we will replace it at
no charge.
2) Oiling the motor's shaft: This is a part of normal service of most
electrical motor components which was accidently left out of the
instructions for your power package.
Please apply one drop of lubricating oil to each end of the shaft. This will
also dramatically increase the motor's performance.
3) Balance the prop and centering the prop are CRITICAL. Being off even 1/16"
will cause a wobble which robs nearly half the available thrust from your
motor combination.
If options 1 through 3 did not solve your performance concerns (acceptable
being flight times of 3-5 minutes with sufficient power for the model to
climb comfortably at a 45 degree angle). please consider:
4) Prop/Gear box match. The 1.7:1 gearbox works well on the Fundango for most
modelers as is, but for some, the performance is increased by using a
9x6 prop. The 3:1 ball bearing gearbox, GPMG0225, does also offer an
increase in performance when using the 10x7 prop already provided with
the power system you previously purchased, or an 11x7 with even more
power system you previously purchased, or an 11x7 with even more power
but shorter run time.
If you have tried options 1 through 4 and performance remains unacceptable,
please mail us your motor/gearbox combination for warranty consideration.
AMC 11/27/00
ir/jl