This is the 1/10 Scale Radio Controlled, Four Wheel Drive (4WD) Glow Powered
     RTR RS4 Super Nitro with Viper GTS-R Body w/ Wing and .15FE Engine.
   This RTR is Larger than a 1/10 Scale, Yet Smaller and Less Expensive Than
      1/8 Scale Kits.  It is Similar in Size to the Kyosho Superten Cars.

FEATURES: An oversized clear lexan Viper GTS-R body with two different wings.
          Body has a clear protective film and supplied window masks.
          Strong 2.5mm purple anodized aluminum chassis with countersunk screws
          Large white 5-spoke wheels (2.2 in. unique to this car).
          Large rubber slick tires with foam inserts (2.2 in. unique to car).
          Two decal sheets for the Viper body.
          A-arm type double wishbone suspension front and rear.
          Tweak screws to adjust ride height for front and rear.
          Adjustable turnbuckles for quick race tweaking.
          Wheelbase is adjustable from 280mm to 300mm for different bodies.
          Unique adjustable body mount system.
          Nylon oil filled coil over shocks with internal bladder and aluminum
            collars, also includes shock oil.
          Front and center belts also include adjustable tensioners.
          Large impact absorbing front bumper.
          Quick release radio plate held in with body clips.
          Standard four wheel drive with triple belt set-up.
          Front and rear gear diffs with disc brake mounted to center pulley.
          Includes a full set of twenty-two ball bearings.
          Pre-installed a recoil started HPI .15FE racing engine with muffler.
          Engine only has one easy to tune adjustment and one idle screw.
          Large capacity flip top lid fuel tank with silicone fuel tubing.
          Engine features small, purple finned heatsink head.
          Standard two shoe clutch system.

INCLUDES: One RTR 4WD Super Nitro RS4, One clear lexan 280mm Viper GTS-R body,
            Two different style spoilers, slick tires, foam inserts, HPI
            Pre-installed 2-channel AM 27Mhz pistol grip radio with Airtronics
            Z-connectors, body posts, 4-cell BEC receiver battery box, wheel
            nuts, Two allen wrenches, turnbuckle wrench, four-way wrench,
            body post plate, antenna tube, wheel drive washers, body pins,
            decals, extra servo arms, and instructions.

SPECS:    Length:      20"   (508mm)
          Width:       9"    (228mm)
          Height:      5"    (127mm)
          Wheelbase:   11.02"(279mm)
          Clutch bell: 13T
          Spur gear:   44T
          Rear belt:   60T
          Center belt: 54T
          Front belt:  157T
          Tires/Wheels: 2.2" (unique to this car, not standard size)

REQUIRES: Radio Batteries: (12) AA size
          Fuel: 2-cycle 10%-40% nitromethane with 18% lubrication
          Glow Plug Igniter: 1.2 volt
          Paint: Polycarbonate for body
          Misc. Items: Final building and track equipment

COMMENTS: For Replacement Bearings, use:
            (6)  4 x 8 x 3mm   (3 of DTXC1511) pilot shaft and diff pulley
            (10) 5 x 11 x 4mm  (1 of DTXC1549) wheel shafts, gear shaft, diff
            (6)  10 x 15 x 4mm (3 of DTXC1595) diffs, front wheel shafts

                                                                   cmc 01/13/02
                                                                          ir/kh