This is a 27" 3.5cc Outboard Fiberglass Lap Cat I Tunnel Hull Boat by Prather.

FEATURES: Epoxy fiberglass hull
          Factory joined deck and hull
          Removable epoxy fiberglass hatch cover
          Foam flotation
          Aluminum turn fin included
          Plywood transom plate factory installed
          Plywood turn fin plate factory installed
          Complete instructions with photos

INCLUDES: Hull, Deck and Hatch
          Turn Fin
          Decals
          Partial Hardware Package

SPECS:    Length: 27"
          Beam: 12"
          Tunnel Width: 6"
          Engine: 3.5cc (.21cu. in.) Outboard

REQUIRES: Accessory Kit  (PRAB3009)       3.5cc Outboard Engine
          Radio Box Kit  (#8103)          2Ch radio w/ one hi-torque servo
          Outboard Cable Set  (PRAB1716)  15 minute Epoxy glue
          Propeller  (PRAQ1315)           CA glue
          Seating Tape (GPMQ4424)         Filler Putty
          Fuel Line  (PRAQ1680)           Prop Balancer
          Antenna  (HAYM1008)             Silver Soldier
          Fuel Tank  (SULQ1438)           Propeller grease (PRAB2045)
          Radio Switch Mount  (DUBM2203)  Electric starter, glow heater
          Fuel                            12v battery, charger
                                          Epoxy paint, sandpaper, masking tape
REQUIRED
   TOOLS: Sandpaper and sanding block
          Screw drivers
          Dremel tool with metal cutter
          Drill and Bits (1/16', 1/8", 5/32",5/64",7/32", 11/64", #43)
          1/2" file
          Pliers
          Soldering
          4-40 tap
                                                                   mgc 10-18-98
                                                                          ir/jl